Description

This is a newly built 17 foot custom Clinker Runabout, designed by Paul Gartside. Built to the highest standards using the finest materials.

The boat has been used three times, with approx. 10hrs on the engine. Reluctant reason for sale is building a new house with no place to store her.

The boat is in as new condition and is ready to go, but the engine will need it's first service/oil change.

Design by Paul Gartside

Built using the following materials:

Vendia Marine Planks frkn Finland(Hull)
Mahogany trim
Okoumi decks
Bronze hardware and fixings from Davey & Co of London
New Honda BF50 outboard
Bronze wheel by Hamilton Marine in the USA
West System Epoxy
Epifanes paint and varnish

Hull and deck are fully epoxy sealed inside and out. Hull is glued clinker construction using Vendia Marine plank from Finland, a strong, high quality boatbuilding specific material. Stronger and higher quality than even the best Marine plywood.

All hardware fixing holes were bored out oversized, filled with epoxy and chopped cloth, then re-bored to correct size to prevent water entering the wood, before bedding hardware in Sikaflex.

Meticulous build quality by custom furniture maker. Build photos available on request.

Custom built galvanised trailer.

New Rocna anchor, fenders, and warps included.

Specifications

Construction

Glued clinker using Vendia Marine plank and west system Epoxy

Equipment

Rocna anchor
Fenders

Navigation Equipment

Silva compass

Engine(s)

New Honda BF50 with approx 10 hrs on it.

Location Map